Community Forum

Ask for ideas, share DIY builds, and swap Skelly tips.

Whether you're engineering a windproof frame, looking for summer costume ideas, or just sharing hilarious neighbor reactions, this is your community workshop.

Filtering by:✅Stage: Completed#safety
Reset all filters
Showing 1 of 1 discussions

Field Guide: How we safely reinforced our 12ft Skelly against 40mph coastal gusts

Every October we see heartbreaking photos of 12ft skeletons folded in half after the first cold front storm. After 5 seasons living two miles off Lake Erie, here is the battle-tested anchoring protocol that has kept our Skelly standing through 40+ mph gale warnings. ### 1. Ditch the stock metal ground stakes The stakes included in the box are only 8 inches long and pull out of saturated mud instantly. Replace them with: - 18-inch heavy-duty steel rebar stakes with welded hook loops. - Spiral auger earth anchors (16-inch minimum) placed at a 45-degree angle opposite the prevailing wind. ### 2. Dual-point internal Guy Lines Do NOT just tie a rope around Skelly's waist — the lateral stress will shear the pelvis joint. Instead, attach stainless steel aircraft wire (1/8") directly to the internal steel spine bracket just below the ribcage connector, and tension them downward to ground augers behind the display. ### 3. Foot Plate Ballast We place two 50-lb sandbags directly on the rear and front feet brackets, covered with faux moss or leaf bags so they blend into the lawn. Drop your questions below if you need advice for your specific soil type or patio setup!

980 views•Active Sep 28